11/2/2023 0 Comments Vcds coding guide pdfDuring the basic setting procedure, there maybe some loud gear shifting noises from the transmission, this is normal.This Basic Settings procedure should also work for the following: 0BT, 0BH, 0DE, 0GC (ref: DQ380, DQ381, DQ500 VAG Direct-shift gearboxes.).(Failure to complete this last step will result in the inability to select any gear!) Close controller Important! Cycle the ignition Off and then Back On! ĭisplay should read Wait for the Press Check for fault codes. Not all transmission controllers support this Basic Settings function.The brake pedal must be depressed during the entire procedure.Parking brake and foot brake applied during the entire procedure.Engine at idle speed, do not press accelerator pedal.No fault codes other than P175F 00 - Basic Settings Not Performed.Transmission fluid level is correct and temperature greater than 15☌ (Do NOT continue if the temp is too low).If the original Coding is unknown, coding information can sometimes be found in the pop-up balloon within the VCDS function.When replacing this Mechatronic unit, if the old Control Module is still accessible, prior to replacement read/copy it's Coding and Paste it into the New coding line of the replacement Module.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |